Pages

Monday, February 12, 2018

Craft a Bird In a Nest Box

The Nesting Bird's Box by kathy grimm as seen from above.
       Although the assembly of this little box may be a bit challenging in at first, most of you will get the gist of it after a few seconds of trial and error. 
       Just imagine how different my box might look if I were to use paper or paint to decorate it? I loved the soft, tactile surface of this box. And the neutral brown shades gave it a bit of a modern twist in the finish, I think. It makes for an unusual Easter surprise!

Supply List:
  • small empty, clean carton with a screw top spout
  • paper or plastic bowl
  • cardstock or cardboard
  • masking tape
  • white school glue
  • plastic or styrofoam eggs
  • yarn for nest, eggs and bird
  • feathers
  • scissors
  • tissue paper 
  • Sculpey clay (just a small amount)
  • hot glue
Step-by-Step Directions:
  1. Clean with warm warm water and soap a screw top spouted cream carton. Then cut the top off including a generous piece of cardboard surrounding it. (see photo below)
  2. Cover the bowl's surface with masking tape on all sides.
  3. Take the paper or plastic bowl and turn it upside down on a piece of cardboard and draw around the edge to estimate the circumference of it's opening. Cut around this circle leaving about a half inch in excess from the drawn circle. 
  4. Remove the plastic lid from the carton piece and trace around it on top of the cardstock where ever you plan to have the box open. If your making a nest similar to mine, put it roughly in the middle.
  5. Punch a whole in the center of this smaller outline with the tip of your scissors and cut the small whole out. Make sure that the lid top fits neatly through the hole.
  6. Cover the top with masking tape. Cut out the hole shape if you cover this with the tape.
  7. Now push the lid opening and it's attached backing through one side of the container's lid. (see photograph below)
  8. Tape this secure and flip it over to screw on the plastic lid top.
  9. Notch around the half inch cut so that the edge may be turned under  or up slightly and then squeeze glue around this edge and nestle it on to the top of the bowl. Mask the top edge firmly to the bowl top. Let this form dry.
  10. Use glue and making tape to position and secure the plastic egg shells around the inside of the nest.
  11. Now unscrew the lid from the top of the box. Crush the tissue into the shape of a small baby bird and glue this to the lid's top. Be careful not to get tape, glue or paper on the inside of the lid so that it will continue to screw on and off of it's lip properly. 
  12. Mask this tiny bird with the tape.
  13. Sculpt a bit of clay into a open beak for the bird. Fit it onto the small bird's head to make sure that it looks the way you want before baking it into it's permanent shape.
  14. After baking this according to directions, let cool and then hot glue it to your baby bird.
  15. Now use the white school glue to cover your nest with yarns of your own choosing. This will need to be done in stages, the bottom first and so on...  Let the glued surfaces dry between stages over several days. (see detailed photos below)
  16. Include a secret letter and perhaps a bit of money inside your bird's nest box to give as a special gift for Easter or a child's birthday.
Left, "Clean with warm warm water and soap a screw top spouted cream carton. Then cut the top off including
 a generous piece of cardboard surrounding it." Right, you can see that I have cut a whole measuring the
 same size of the lid into the top of the cardboard "nest."
Left and Center, "Now push the lid opening and it's attached backing through one side of the container's lid.
Right, the opening of my Nest Box is neat, clean, and ready for decorating.
Left, "Now unscrew the lid from the top of the box. Crush the tissue into the shape of a small baby bird and glue
 this to the lid's top. Be careful not to get tape, glue or paper on the inside of the lid so that it will continue to screw
 on and off of it's lip properly." Right, "Use glue and making tape to position and secure the plastic egg shells around
the inside of the nest."


       Above is the top of the screw top lid covered with furry brown yarn, a Sculpey beak and real feathers, made to look like a baby bird. I went for a simpler look and opted to leave the beak unpainted this time. In the photographs below you can see the yarn covered box from different points of view as well as a close up shot of the box with the led unscrewed.



More Bird Crafts:

No comments:

Post a Comment

Thanks for your thoughts. All comments are moderated.